Antec AT100 Bedienungsanleitung PDF herunterladen (Seite 9)

2.3

OTHERBOARD

NSTALLATION

1. Lay the case down, with the open

side facing up. The drive cages and

power supply should be visible.

2. Make sure you have the correct I/O

panel for your motherboard. If the

panel provided with the case isn’t

suitable, please contact your

motherboard manufacturer for the

correct I/O panel.

3. Align your motherboard with the

standoff holes and remember which

holes are lined up. Not all

motherboards will match with all the provided holes; this is normal and won’t affect its functionality.

4. Remove your motherboard by lifting it up.

5. Install standoffs as needed and put the motherboard back in.

6. Screw in your motherboard to the standoffs with the provided Phillips-head screws.

2.4

NTERNAL

3.5”

EVICE

NSTALLATION

The One Hundred provides space for up to six 3.5” hard drives.

1. Insert your 3.5” device into the 3.5” drive cage from the rear of the case until the mounting holes align

with the screw holes in the cage.

2. Fasten the device in place with the provided screws.

3. Mount any other 3.5” HDD devices accordingly.

4. Connect the appropriate power and data cables to the device(s).

Note: The One Hundred comes with a CPU cutout on the motherboard tray, which will allow

you to change your CPU heatsink without removing the motherboard.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Keine Kommentare

Antec AT100 Bedienungsanleitung Seite 9