Antec SKELETON Bedienungsanleitung PDF herunterladen (Seite 6)

2. To completely remove the Component Tray from the Frame, find the release

tab on the lower left side of the Component Tray when the Tray is fully extended.

Press it upwards, then pull the Tray out and completely free of the Frame.

3. To replace the Component Tray in the Frame, align the Tray with the back of

the case, and slide it forward. Once completely inserted, replace the

Component Tray screws along the inside of the Component Tray.

2.2 Removing the Motherboard Tray

Remove the Component Tray from the Frame as detailed in section 2.1.

1. Remove the two screws holding the removable Motherboard Tray to the top of the

Component Tray.

2. Remove the Motherboard Tray and place it on a flat, stable surface.

3. To replace the Motherboard Tray, slide the Motherboard Tray onto the top of the

Component Tray from the front such that the tray clips underneath the Component

Tray clips. Secure the Motherboard Tray in place with the provided screws.

2.3 Motherboard Installation

Remove the Component Tray from the Frame and the Motherboard Tray from the

Component Tray as detailed in sections 2.1 and 2.2.

1. Line up the motherboard with the standoff holes on the Motherboard Tray.

Determine which holes line up and remember where they are. Not all mother-

boards will match with all of the provided screw holes, and this is not necessary

for proper functionality. Some standoffs may be pre-installed for your convenience.

2. Lift up and remove the motherboard. Screw in the brass standoffs to the

threaded holes that line up with the motherboard.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Antec SKELETON Bedienungsanleitung Seite 6