Antec AT100 Bedienungsanleitung

ON E HU N D R E D WALLET-FRIENDLY INTENSITY US E R MA N U A L

9 2.5 EXTERNAL 5.25” DEVICE INSTALLATION There are three externally accessible 5.25” drive bays. To access these bays, you must first rem

10 2.7 CABLE MANAGEMENT There is a cable management compartment behind the 3.5” drive cage. You can tuck or route excess cables in this

11 FRONT I/O PORTS SECTION 3

12 Pin Signal Names Pin Signal Names 1 USB Power 1 2 USB Power 2 3 Negative Signal 1 4 Negative Signal 2 5 Positive Signal 1 6 Positive Signal 2 7 Gr

13 3.3 POWER SWITCH / HARD DISK DRIVE LED CONNECTORS Connected to your front panel are LED and switch leads for power and HDD LED acti

14 4.1 INCLUDED FANS Rear TwoCool™ Fan – There is a 120 x 25 mm TwoCool™ fan preinstalled at the rear of the case. The fan is installed

15 4.2 OPTIONAL FANS There are total of three optional 120 mm fan mounts—one side intake fan (on the left side panel) and two front in

16 Antec, Inc. 47900 Fremont Blvd. Fremont, CA 94538 USA tel: 510-770-1200 fax: 510-770-1288 Antec Europe B.V. Stuttgartstraat 12 3047 AS Rott

1 ONE HUNDRED USER MANUAL Congratulations on your purchase of the Antec One Hundred. Antec’s One Hundred is the gaming case that delivers high-end

2 TABLE OF CONTENTS SECTION 1: INTRODUCTION 1.1 Case Specifications ...

3 INTRODUCTION SECTION 1

4 ONE HUNDRED USER’S MANUAL 1.1 CASE SPECIFICATIONS Case Type Gaming Mid Tower Color Black Dimensions 480 mm (H) x 198 mm (W) x 477 mm

5 1.3 INCLUDED SCREWS A. Motherboard standoff (10; 6 preinstalled) B. Power supply / expansion slot screw (12) C. Hard drive

6 HARDWARE INSTALLATION SECTION 2

7 2.1 SETTING UP 1. Place the case upright on a flat, stable surface with the rear of the case facing you. 2. Remove the side panel

8 2.3 MOTHERBOARD INSTALLATION 1. Lay the case down, with the open side facing up. The drive cages and power supply should be visible. 2.