Antec Three Hundred Two Bedienungsanleitung Seite 4

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 7
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 3
3
Connecting the Audio Ports (AC’97 and HDA)
There is an Intel® standard 10-pin AC’97 connector and an Intel® 10-pin HDA (High Definition
Audio) connector. You can connect either the AC’97 or the HDA connector, but not both at
once, to your motherboard depending on the spec of the motherboard.
Pin Assignment for Audio Ports (HDA and AC’97)
Locate the internal audio connectors from your motherboard or sound card. Consult your
motherboard or sound card manual for the pin-out positions.
Pin Assignment for Audio Ports (HDA and AC’97)
Pin
Signal Names
(HDA)
Pin
Signal Names
(AC’97)
1 MIC2 L 1 MIC In
2 AGND 2 GND
3 MIC2 R 3 MIC Power
4 AVCC 4 NC
5 FRO-R 5 Line Out (R)
6 MIC2_JD 6 Line Out (R)
7 F_IO_SEN 7 NC
8 Key (no pin) 8 Key (no pin)
9 FRO-L 9 Line Out (L)
10 LINE2_JD 10 Line Out (L)
1
2
3579
46
10
External 5.25” Device Installation
1. Remove both side panels and front bezel per the instructions in Setting Up.
2. Remove the drive bay faceplate from the bezel.
3. Slide the 5.25” device into the bay from the front of the case.
4. Fasten the drive using the screws that came with your drive.
5. Connect the appropriate power and interface connectors from the power supply and
motherboard to the device.
6. Mount the other devices accordingly.
3.5” Hard Drive Installation
1. Remove both side panels and front bezel per the instructions in Setting Up.
2. There are two 120 mm fan cages at the front. Each fan cage covers 3 HDD bays and is
fastened by two thumbscrews.
3. Loosen the two thumbscrews. Swing open the fan cage and gently lift upwards to
remove it. Up to six hard drives total can be installed.
4. Slide a hard disk into a bay from the front of the case.
5. Fasten the drive in place using the thumbscrews that came with the case.
6. Connect the appropriate power and interface connectors from the power supply and
motherboard to the device.
7. Repeat the procedure for additional drives as necessary.
8. Put the front fan cages back to the case. If you plan to mount the optional 120 mm
case fans, you should do it now. See Cooling section for fan installation.
Seitenansicht 3
1 2 3 4 5 6 7

Kommentare zu diesen Handbüchern

Keine Kommentare