5
Note: The minimum voltage to start a typical TriCool™ fan is 5V. We recommend that you
set the fan speed to High if you choose to connect the fan(s) to a fan control device or to
the Fan-Only connector found on some Antec power supplies. A fan control device regulates
the fan speed by varying the voltage, which may start as low as 4.5V to 5V. Connecting a
TriCool™ fan set on Medium or Low to a fan-control device may result in the fan not being
able to start because the already lowered voltage from the fan control device will be further
reduced by the TriCool™ circuitry below 5V.
The Optional Fans
There are total of three optional 120mm fan mounts—one side intake fan (on the left side
panel) and two front intake fans (at the front of the HDD cage). We recommend using Antec
120mm TriCool™ fans and setting the speed to Low. These fans must be installed so that the
air is blowing into the case.
The Side 120 mm Fan — The side fan opening is there to enhance graphic cards cooling. The fan
should be installed so that air is blowing into the case.
The Front 120 mm Fans — You can install two 120 mm fans to the fan cages in front of the
hard drive bays.
Note: These fans must be installed so that the air is blowing into the case.
1. Remove the front bezel per the instructions in Setting Up.
2. Loosen the two thumbscrews on one of the fan cages. Swing
the cage partially open and lift up to remove it from the case.
3. Line up the fan so that it will be blowing air into the case and
secure it with the screws that come with your fan.
4. Hook the fan cage back onto the front of the case. Run
the power connector through the oval opening to the right
of the HDD bays and into the cable
management area.
5. Close the cage, being careful not
to pinch the wires, and tighten the
thumbscrews.
6. Connect the fan to a power source, and
repeat for the second fan cage if you
choose.
The Washable Air Filter
The front air filter – There is a filter located behind the front bezel.
To remove the filter:
1. Remove the front bezel per the instructions in Setting Up
2. There is a tab on the left upper corner of the filter. Lift that tab
while releasing the latches down the side of the filter that secure
it to the bezel.
From time to time it will be necessary to wash the installed air filter. Not washing the
air filter will result in higher system temperatures and possible stability problems. We
recommend checking the air filter at least once a month initially. The frequency will change
depending on system usage (users whose systems run 24/7 will likely have to check/wash
more often than those who don’t use their systems every day) and on environmental
conditions.
(23 Seiten)
(5 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern