Antec One S Bedienungsanleitung PDF herunterladen (Seite 9)

Chapter 2 Installation 7 (of 12)

Verified by (customer): ………………………….. Deviations (Y/N): ……

Comments:

Installation procedure

A ROXY

system installation checklist is supplied with every ROXY EC

system. It is a general check list to guide you through the installation of an

ROXY

EC system. The full instrument installation procedure of the sup-

plied equipment is described in the corresponding user manuals (Chapter

"Installation Guide"). Installation details of the ReactorCell are described in

the ReactorCell user manual (Chapter "Installation of .."). It is the users’

responsibility to prepare an installation site according to environmental

specifications as described in the ROXY user manuals.

For a successful installation a few preparations must be made. This is a

responsibility of the end-user. Note that all these issues are explained in

detail in the ”Installation Guide” of the user manual.

1. The mass spectrometer (MS) can be controlled by the ROXY EC sys-

tem by contact-closure. The end-user should make sure that all re-

quired preparation with respect to the MS are accomplished:

[a] An open-ended IO cable or screw terminal connector should be

available on the MS side to connect the ROXY trigger cable.

[b] The MS software should be configured in slave mode to be able to

start runs controlled via contact closure by means of the Dialogue

software.

2. A number of operating supplies and consumables should be available.

Chemicals (including water) used for preparation of mobile phase must

be of HPLC grade or better.

3. In a multi-purpose lab (that is not ECD-only) precautions should be

taken to avoid contamination of high purity chemicals. We advice to

keep a separate set of buffer salts, standards, glass ware and other

small supplies for ECD and MS only.

4. If the ROXY is used in the reductive mode (at a negative working po-

tential) additional steps should be taken to remove oxygen from the

mobile phase.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Antec One S Bedienungsanleitung Seite 9