Antec CS-52553CB Bedienungsanleitung PDF herunterladen (Seite 5)

4. Front Right Speaker Out Pin: Connect the FPOUT-R connector to this pin.

5. Front Left Speaker Out Pin: Connect the FPOUT-L connector to this pin.

6. Rear Right Speaker Out Pin: Connect the RET-R connector to this pin.

7. Rear Left Speaker Out Pin: Connect RET-L connector to this pin.

Flexi Drive Bay System

The Nine Hundred comes with nine 5.25” external drive bays at the front of the

case. There are two HDD cages preinstalled inside the bottom six 5.25” bays.

Each HDD cage occupies three consecutive 5.25” drive bays and can house three

hard disk drives. For maximum flexibility you can mount the HDD cage anywhere

within the external drive bays (you are not limited to the bottom six bays).

Possible Drive Bay combinations include but are not limited to:

External 3 x 5.25” + internal 6 x HDD – default

External 9 x 5.25”– by removing both HDD cages

External 6 x 5.25” + internal 3 x HDD – by removing one HDD cage

External 3 x 5.25” + internal 3 x HDD + VGA cooling duct – by adding the

Middle Fan to one of the HDD cages (see below)

External 5.25” Device Installation

Note: The HDD cages each occupy three consecutive drive bays, and will block

installation of larger devices such as optical drives, so please plan ahead before

installing your drives.

1. Remove both side panels per the instructions in

Setting Up.

2. Remove the screws fastening the appropriate

metal drive bay cover(s) to the sides of the case.

Remove the cover(s).

3. If necessary, please remove the HDD cage that

is preinstalled in the bay.

4. Slide the 5.25” device into the bay from the

front of the case.

5. Fasten the drive using the screws that came

with your drive.

6. Mount the other devices accordingly.

7. Connect the appropriate connector(s) from the power supply to the device(s).

3.5” Hard Drive Installation

There are two HDD cages provided with the case. Each can store three hard disk

drives.

1. Remove both side panels per the instructions in

Setting Up.

2. Remove the thumbscrews fastening the HDD

cage to the 5.25” drive bays, and set them

carefully aside. Note: do not confuse the HDD

cage thumbscrews with the side panel thumb-

screws, as they are different.

3. Slide the HDD cage forward out of the front of

the case to remove it from the case.

1 2 3 4 5 6 7 8 9

Kommentare zu diesen Handbüchern

Keine Kommentare

Antec CS-52553CB Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computergehäuse Antec CS-52553CB