Antec CS-52553CB Bedienungsanleitung PDF herunterladen (Seite 6)

4. Mount the hard drive into the drive cage and

fasten it using the screws provided in the tool

bag.

5. Repeat the same procedure for the other HDD(s)

as necessary.

6. Slide the HDD cage back to the case and fasten

the thumbscrews.

7. Connect the appropriate connector(s) from the

power supply to the device(s).

Note: There is a middle fan bracket pre-installed

on one of the HDD cages. Remove the middle

fan bracket from the HDD cage if you decide to

mount your hard drives into this cage.

External 3.5” Drive Installation

In the toolbox you’ll find a 3.5” to 5.25” drive bay adapter tray and an external

3.5” to 5.25” drive bay adapter cover.

1. Remove both side panels per the instructions in Setting Up.

2. Remove the drive bay cover from the drive bay you wish to install an external

3.5” drive into.

3. Install your external 3.5” device into the tray.

4. Slide the drive tray/device assembly into the bay. Screw the tray to the drive

cage.

Cooling System

The Top 200mm TriCool™ fan:

Antec understands you desire the coolest gaming system, that’s why the Nine

Hundred comes with a 200mm TriCool™ fan. This fan has a three-speed switch that

lets you choose the speed best suited to your needs. The default setting is Low.

The Front TriCool™ fans:

Nine Hundred comes with two 120 x 25mm TriCool™ blue LED fans which are

pre-installed in front of each HDD cage to cool the hard drives. These fans are

installed so the air will be blown into the case.

1 2 3 4 5 6 7 8 9

Keine Kommentare

Antec CS-52553CB Bedienungsanleitung Seite 6